I. Overview of the Product

1.1 Models that are Applicable

USR-N580

USR-N580 Wireless Serial Ethernet Converter

1.2 Power Supply

9 to 36 volts

1.3 Serial Port Communication

RS485

RS485 communication protocol

1.4 Maximum Number of Serial Ports for Conversion

Route Eight

1.5 Default Parameters

Default IP Address: 192.168.0.7
The Default Username: admin
Default Password: admin

1.6 Serial Port Server Version

Firmware Version: V1.0.13
Device Type: H7

1.7 Manual

USR - N580_V1.0.1 PDF
USR - N580 - H7_software_V1.0.1 PDF

1.8 Dimensional Drawing

Two, Parameter Configuration

2.1 Login

1. You can access the login page via the web. The default IP address, username, and password are provided for initial login.

2. Click on the top right corner of the webpage to switch to Chinese and then adjust the settings.

3. Modify the IP address to 192.168.192.105 and save the settings.

4. Configure serial port settings and port numbers to match the device parameters. Modify the port number as needed.

5. Adjust settings and reboot the device.

Three, Instructions for Wiring

3.1 Connecting Network Ports to SRC

The network port of the serial port server can be connected to the network switch port of the SRC.

3.2 Serial Port Connection

The device to be converted is connected to the serial port of the serial port server. Each port corresponds to a unique port number (which can be modified by the user).

5. Model Configuration

5.1 Configuring the Code Reader Camera is used as an example

Choose communication mode:TCP
IP: Refers to the IP address of the serial port server
Port Number: Enter the port number of the serial port
Other configurations are the same as those in serial port mode. Save and upload the model file to complete normal communication. The effect is the same as that of serial port communication mode.