1. Prepare the server

1. Get the server ready

1. Inspect the server chassis and ports for any damage

2. Verify that the server's hardware configurations match the requirements

3. Connect the keyboard to the monitor

Two, prepare the U disk restoration disk

2.1 Download the image file based on the server selection

2.2 Decompress the downloaded image file and copy it to the following directory on the USB flash drive

Step Three: Insert the USB flash drive into the server

4. Access the BIOS

1. Start up and access BOOT

2. When this screen appears, quickly press F11 and enter Boot Boot option.
   

3. Choose "One-shot UEFI Boot Menu".
   

4. Select "Generic USB Boot", and then automatically enter the USB flash drive system.
   
   

5. The USB flash drive recovery system page is displayed.
   

5. System Restoration

According to the Enter continue

According to the Ctrl+C continue

Select the partition of USB flash drive to store the image. The remaining space of our USB flash drive is about 115G, so select the one in the picture above


Select the directory where the image is stored, because the image is stored in the same directory, so press here Tab Key, select Done, press again Enter

According to the Enter continue

Select Expert Mode


Select the image file to use

Select the hard disk that you want to restore

According to the Enter

According to the Enter

If no, skip the check

Select the figure

According to the Enter

y, press Enter

y, press Enter

Wait for...

Wait for...

Wait for...

Wait for...

Wait for...

Wait for...

Wait for...

Wait for...

Wait for...

Wait for...
Wait for...

restart

6. Update the entire package

Install the corresponding versions of robod, rds, and rdscore.